The influence of drug physical state on the dissolution enhancement of solid dispersions prepared via hot-melt extrusion: a case study using olanzapine.

In this study, we examine the relationship between the physical structure and dissolution behavior of olanzapine (OLZ) prepared via hot-melt extrusion in three polymers [polyvinylpyrrolidone (PVP) K30, polyvinylpyrrolidone-co-vinyl acetate (PVPVA) 6:4, and Soluplus® (SLP)]. In particular, we examine whether full amorphicity is necessary to achieve a favorable dissolution profile. Drug­polymer miscibility was estimated using melting point depression and Hansen solubility parameters. Solid dispersions were characterized using differential scanning calorimetry, X-ray powder diffraction, and scanning electron microscopy. All the polymers were found to be miscible with OLZ in a decreasing order of PVP>PVPVA>SLP. At a lower extrusion temperature (160°C), PVP generated fully amorphous dispersions with OLZ, whereas the formulations with PVPVA and SLP contained 14%-16% crystalline OLZ. Increasing the extrusion temperature to 180°C allowed the preparation of fully amorphous systems with PVPVA and SLP. Despite these differences, the dissolution rates of these preparations were comparable, with PVP showing a lower release rate despite being fully amorphous. These findings suggested that, at least in the particular case of OLZ, the absence of crystalline material may not be critical to the dissolution performance. We suggest alternative key factors determining dissolution, particularly the dissolution behavior of the polymers themselves.

Determination of partial solubility parameters of five benzodiazepines in individual solvents.

Three and four component partial solubility parameters for diazepam, lorazepam, oxazepam, prazepam and temazepam were determined using the extended and expanded Hansen regression models. A comparison was made also with solubility parameters calculated by the group contribution method proposed by Van Krevelen. Although a limited number of solvents was used, the results from the present study indicate that the partial solubility parameters obtained from the experimental regression models clearly reflect the structural differences in these five structurally related molecules. High R(2)-values were observed in the regression models (0.932 < or =R(2)< or =0.984), except for lorazepam (0.606 < or =R(2)< or =0.825). This was attributed to difficulties in obtaining reliable values of the temperature and heat of fusion due to thermal decomposition of this compound. Introduction of the Flory-Huggins size correction parameter did not improve the R(2)- and F-values in any of the regression models used.